Steel Bar Bender

How to Maintain The Steel Bar Bender Machine?

1. The workbench and the bending machine workbench should be kept level, and various tools should be prepared.

2. Install the mandrel and forming shaft according to the requirements of the diameter and bending radius of the processed steel bar.

3. Check whether the mandrel, plug and turntable are intact and have no cracks. The protective cover should be reliably fixed, and the operation can only be performed after confirming that the operation is normal.

4. The steel bars should be close to the baffle, pay attention to the rotation position and direction of the plug, and do not place it in the wrong position.

5. During the operation, insert one end of the steel bar to be bent into the gap of the fixing pin of the bending machine turntable, and the other end is close to the fixing pin of the fuselage, and then press it toward you by hand. Please check the fixing pin of the fuselage before starting.

6. During the operation, it is strictly forbidden to replace the spindle, pin, change the angle and speed, do not add oil or clean.

7. When bending steel bars, it is strictly forbidden to exceed the diameter, quantity and mechanical speed specified by the machine.

8. When bending a long steel bar, someone should hold it and stand outside the bending direction of the steel bar. They should cooperate with each other without dragging down.

9. Turn around and bend to prevent collision with people and objects. After stopping, the plug must be replaced, oiled and cleaned.

10. When bending high-strength or low-alloy steel bars, the maximum limit diameter should be converted according to the mechanical nameplate, and the corresponding mandrel should be replaced.

11. It is strictly forbidden to stand on the side of the steel bar bending radius and the side of the fuselage without fixing pins. The bent semi-finished products should be stacked neatly and the hooks should not face upwards.